Philio Roller Shutter Controller

With the Philio Roller Shutter Controller, shutters, awnings, electric blinds, motorized curtains, and garage doors can be easily integrated into a Z-Wave network. Thanks to it, any device that is powered by an AC electric motor can be remotely controlled.

This insert is able to detect the position of the shutter by using the patterned power measuring method. This way, it can be remotely controlled not only fully up or down, but also can be adjusted to e.g. 30% or 50%. And when manually controlled by using the push button, the controller also can memorize the position and send the new shutter position to its controller (e.g. IP gateway).

The shutter control module allows precise positioning of motors with mechanical and electrical end switch. Furthermore, the device allows current monitoring. The compact radio module is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as an input device for the PHILIO insert that is controlling the load. The switch only sends a control signal to the insert which controls the load then again. The solution works with all switch design. You can use a momentary or a toggle switch. It’s recommended to use wall boxes with 65mm depth. But smaller boxes with only 45mm depth can be used also if there is enough space behind the switch. The available space depends on the size of the traditional switch, the dimensions of the wall box, and the amount of additional cabling placed in this box.

Specifications

• Precise positioning of motors with mechanical and electrical end switch
• The flush-mounted radio module
• Power Measurement – Instant and Accumulated power consumption
• Integrates electric motors in blinds, shutters, and curtains into a Z-Wave network
• Works with momentary or toggle switches and by dedicated roller blind control switches
• Requires 3-wire (including neutral) installation
• Power Measurement – Instant and Accumulated power consumption
• Includes calibration so that blind can be controlled correctly
• Overload warning alert (configurable)
• 100-240V AC 50Hz mains only